shutter door roll forming machine/roller shutter door machine

Specifications roller shutter door machine

  . Introduction of Roller shutter door roll forming machine 
The line consists of decoiler, sheet guiding equipment, roll forming section, cutter, supporter, hydraulic system, control system. The roller shutter which made by this machine have neat external appearance, even ripples, high utilization and strong strength.

  2. Technical Parameters

No	Item		Parameter	Note
1	Suitable   Material	Type	Steel sheet
		Roller Shutter	Thickness: 0.7-1.0 mm
2	Product Specifications	Detail as the attached drawing
3	Power Requirement	Type	380V/3PH/50HZ
		Main motor power(KW)	3
		Cutting power(KW)	2.2
4	Forming Speed(m/min)		15-18
6	Forming Stand		12	Depend on actual design
7	Forming Shaft Diameter(mm)		65	Depend on actual design
8	Type of Cutting		Roll-formed and length-set cutting
9	Control System		Mitsubishi PLC and inverter
10	Run Out Table		2mX3
11	Installation Dimension(m)		8X1.5	Without the panel length
12	Total Weight(T)		8	Depend on actual design

 

Contact us if you need more details on Machine. We are ready to answer your questions on packaging, logistics, certification or any other aspects about Shutter、Door. If these products fail to match your need, please contact us and we would like to provide relevant information.

Product Categories : Wall And Roof Roll Forming Machine